METAL MOLD WICK KIT

Description

Wick your molds faster and easier with the Metal Mold Wick Kit! This system uses reusable metal washers and foam gaskets, which eliminate the need for messy mold sealer. The specially designed wick holder keeps the wick straight, centered, and taut.

Set includes 2 wick bars, 2 foam rubber gaskets, 2 metal washers, and instructions.

Replace gaskets and washers with our Metal Mold Wick Kit Refill.

---

The bar has a “v” shape slot at one end in order to hold your wick tight. After threading your wick through all holes and placing the mold bar flush against the mold, pull wick towards “v” slot then down into the slot to hold and secure wick, You may want to wrap it around the mold once or twice to hold wick securely.

Just tie a slip knot at the lower end of wick, thread other end through metal washer, then push through rubber washer.

Pull wick through the mold, continue to the mold bar and then towards the “v” shape slot.

Move mold bar flush against the mold, lock wick tight into “v” shape slot on wick bar. You are now ready for pouring your candle.

Use sewing needle to make a tiny hole in the rubber washer in order to feed the wick through. Be careful not to make a large hole otherwise the wax could leak through the rubber washer.